distance from the guard end to the centre shaft of the tail drum should be a minimum of 1000mm. Guards should be provided on the underside of the conveyor to prevent access

Figure 1 shows an inadequate conveyor tail pulley guard. The rear and top of the pulley are fully exposed providing access to moving machine parts. Figure 1 5 . The guard in Figure 2 covers

unit operable, but required frequent realignment. During realignment, the tail take-up pulley guard had to be removed and the conveyor belt then.

Outotec offers head pulleys, conveyor pulleys, tail and wing pulleys, snub, drive, bend and take-up pulleys for your needs - standard or tailored.

Brelko Nip Guards improve worker safety around head, tail, and drive pulleys. Brelko Nip Guards prevent worker exposure to conveyor pulley nip points and 

End pulley guards properties and features. At the point where the belt meets the tail pulley, there is always a risk of operators or anyone else in the area 

the moving conveyor belt on the in- AREAS WHERE NIP GUARDS ARE It also helps in protecting head & tail pulleys & increases the life of these.

03/06/  · Figure 2-13 Surrounding fixed guard for pulleys and power transmission 33. Figure 2-33 Surrounding fixed guard for tail drum 46. Figure 2-35 Fixed guard at conveyor belt junction 48.

Tail pulley: the terminal pulley at the loading end of the conveyor. Guard between the conveyor belt and the tail pulley for the in-running 

By: Belt Conveyor Guarding www.conveyorguarding.com A typical conveyor belt travels in the range of 600 feet per minute. Tail Pulley. Before & After 

Enduride Safety Nets Guards for Conveyor Belts or Machine Guarding. Since safety is everyone's responsibility, it is essential to protect people while keeping production imperatives in mind. Heavy and corroded steel or plastic guards panels, although safe, may lead to operational problems and even certain hazards that could cause injuries.